Quantum Scalar 218 Dokumentacja Pobierz pdf (Strona 54)

44 Operation and Maintenance

Drive Status

After completion of the drive POST and initialization, each drive will be in one of the four

states listed in the following table:

Drive State Indicator Displays and Actions

1. No cartridge is present

A. The Tape in Use LED turns OFF.

B. The Operate Handle LED turns ON.

C. The handle is unlatched.

D. The drive beeps momentarily.

2. A cartridge is present

and the handle is

closed.

The drive loads the cartridge. When the Tape in Use LED

stops blinking and stays ON, the tape’s actual density lights. For

example, if the actual tape density is 2.6, then the LED turns ON

next to the 2.6 label. When the Density Override LED blinks,

you can select a density. The drive is ready for use.

3. A cartridge is present,

but the handle is open.

The Tape in Use LED turns OFF. The Operate Handle

LED flashes. The Scalar Library will close the handle and the

drive will load the cartridge. When the Tape in Use LED stops

blinking and stays ON, the tape’s actual density lights. For

example, if the actual tape density is 2.6, then the LED turns ON

next to the 2.6 label. When the Density Override LED blinks,

you can select a density. The drive is ready for use.

4. The drive detects an

error condition.

Then all right or left side LEDs blink repeatedly. You may try to

unload the tape and reinitialize the drive by pressing the

Unload key or turn power OFF and then ON again. The right or

left side LEDs stop blinking and the drive tries to reinitialize.

The LEDs turn ON steadily again and then turn OFF if the test

succeeds.

The drive POST completes in about 13 seconds on each drive, and the drives will respond

normally to all commands. However, it may take longer for the media to become ready.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 108 109

Brak uwag

Quantum Scalar 218 Dokumentacja Strona 54