Quantum TC2201E Podręcznik Użytkownika Pobierz pdf (Strona 46)

Chapter 2 Getting Started

Configuring the TC2201E

26 Quantum TC2201E User’s Guide

configured for network operation of the TC2201E. Depending on the

network environment, it may be possible to use the TC2201E’s

default IP address of 1.1.1.1 to configure the unit.

2 Verify that the Ethernet and iSCSI ports all have good network

connections. This can be accomplished by issuing a standard “ping”

command to the IP addresses for each port. In the event that a port

fails to respond, check all cable connections (use new cables where

necessary) and be sure there is a good link light showing on the

network switch for all connections to the TC2201E.

3 To begin configuration of the TC2201E, enter the IP address of the

Ethernet management port into the web browser address field and

press the

Enter key. The home page of the TC2201E should appear. If

not, please verify the IP address or use the Command Line Interface

instructions in the next section.

4 In the Home page of the Visual Manager interface, select “Ethernet”

from the Main menu on the left.

5 When the security prompt appears, enter the appropriate user name

and password values and then select the

Submit button. The default

user name is ‘root’ and the default password is ‘password’.

6 The Ethernet page will appear. Select each Ethernet port from the

menu on the left and verify that all Ethernet settings are correct for

the network environment that the TC2201E is connected to.

7 Select the Discovery page to verify that all target devices are visible as

expected and that the status for each device appears as expected (i.e.

in the “UP” state). If any device is shown in the “DOWN” state,

inspect that device. If a device fails to appear at all, make sure the

Note: In the event that DHCP is not used, note that the

TC2201E’s default IP address of 1.1.1.1 is technically not a

valid IP address. It is recommended that you should

change the setting to an IP address that is a valid address

(via the serial port using the Command Line Interface).

Refer to Using the Command Line Interface

on page 103

for information on configuring the IP address.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 201 202

Brak uwag

Quantum TC2201E Podręcznik Użytkownika Strona 46