
18 Getting Started with Pathlight VX
9 Turn on each DPE.
• If the back panel contains power buttons, place them in the on position.
• If the back panel does not contain power buttons, plug each power supply/cooling module's power
cord in an AC power source.
10 Turn on the MS by pressing the power button on the front panel.
The MS turns on. The boot process takes approximately 25 minutes to complete; more time if the
Pathlight VX is a High-Performance Configuration.
If you hear an audible alarm, receive a RAS service ticket indicating a failure when logging on the
Pathlight VX User Interface or a Pathlight VX component fails to start, there is a problem with the start
up process. Refer to Modifying Service Tickets
on page 137 and Interpreting Status LEDs on page 151.
Related topics:
Shutting Down the Pathlight VX
on page 19
Rebooting the Pathlight VX
on page 25
MS LEDs
on page 152
SNC LEDs
on page 157
AX100SC LEDs
on page 161
DPE/DAE LEDs
on page 163
SPS LEDs
on page 168
FC Switch LEDs
on page 169
CAUTION
The MS checks the battery for the DPE (located in the SPS) before it boots
up the software. If the battery needs to be charged, it can add an additional
30 minutes to the startup time for the MS.
CAUTION
Do not interrupt the MS boot process before it completes. If the MS does not
boot up completely, the Pathlight VX may not operate properly.
Komentarze do niniejszej Instrukcji