Quantum LTO 1 Informacje Techniczne Pobierz pdf (Strona 10)

10 Installing the Tabletop LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive Quick Start Guide

2 Connecting the Tabletop Drive Interface and AC Power Cables

3 Restarting the Tabletop Tape Drive System on page 13

4 I

nstalling the LTO Driver Software on page 13, if required

5 Registering the LTO-3 Half-Height Tape Drive

on page 13

Configuring the Tabletop

Parallel SCSI Tape Drive 0

The factory-set default configuration of the tabletop parallel SCSI LTO-3 Half-Height

Tape Drive is:

• SCSI ID: 6

• Terminator power: enabled

Configuring the Tabletop Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID. Use the push-

button SCSI ID selector switch on the drive back panel to change the SCSI ID of the

tabletop LTO-3 Half-Height Tape Drive (see

figure 8).

Figure 8 Tabletop Parallel

SCSI ID Selector Switch

IF the default parallel SCSI ID

configuration is . . .

THEN you can . . .

compatible with your system

SCSI bus,

skip the following subsection and proceed to

onnecting the Tabletop Drive Interface and AC

Power Cables on page 11.

already assigned to another

device,

change the configuration of either the other

device, or the LTO-3 Half-Height Tape Drive, as

described in the following subsection.

Note: You cannot disable terminator power on a tabletop parallel SCSI drive.

Note: Parallel SCSI controllers and host adapters generally use ID 7. In some systems,

the boot drive uses ID 0 or ID 1. Avoid configuring the LTO-3 Half-Height

Tape Drive to these SCSI IDs.

Parallel SCSI ID selector switch

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Quantum LTO 1 Informacje Techniczne Strona 10