Quantum DAT 432/864 Loader Podręcznik Użytkownika Pobierz pdf (Strona 35)

Operating Your Autoloader Preparation for Shipping

Each time the cleaning cartridge is loaded, a new, unused portion of cleaning tape is advanced

over the entire tape path. The drive does not rewind a cleaning cartridge. After about 30 cleaning

cycles, the entire tape is used up, and you must purchase a new cleaning cartridge.

If you insert a cleaning cartridge that has been used up, the cleaning cycle will not be carried out.

Instead, the Clean LED will flash rapidly and the LCD will display the message, “REPLACE

CLEANING TAPE.” The cleaning cartridge will not be returned to the magazine, the Clean LED will

stay on, and the LCD will display the message, “CLEANING REQUIRED.” In this case, press the Eject

button to remove the magazine and replace the spent cleaning cartridge with a new one.

Automated Cleaning

If your backup-and-restore software includes a tape drive head-cleaning feature, you can use the

software to clean the autoloader. Some software packages are preprogrammed to use the cartridge

in slot 6 to clean the tape path automatically. The software prompts the autoloader to load the

cleaning cartridge and initiate the cleaning cycle. When the cleaning cycle completes, the tape

drive ejects the cleaning cartridge and automatically returns it to the original magazine slot. Refer to

your software documentation for details.

If, during automated cleaning, a cleaning cartridge is loaded that has been used up, the cleaning

cycle will be aborted. Instead, the LCD will display the message “REPLACE CLEANING TAPE”, and

the cleaning cartridge will be returned to the magazine. The Clean LED will stay lit, and the LCD will

display the messages “REPLACE CLEANING TAPE” and “CLEANING REQUIRED”. After the software

operations are complete, you may use the Eject button to remove the spent cleaning cartridge and

insert a new one.

Preparation for Shipping

Before shipping the autoloader, you must secure the autoloader door to prevent damage to the

device. Follow the procedure below to secure the door as the last step before switching off the

autoloader:

1. Make sure there is no magazine in the autoloader. The LCD should display the message “NO

MAGAZINE.”

2. Press and hold the Select button for 5 seconds. The LCD should show the following menu:

>VERSION

LANGUAG

CONTRAST

3. Press the Select button four times. The cursor (>) will move down to the word “DOOR,” as

shown below:

CONTRAST

AUTO/LD

>DOOR

4. Press the Enter button. The LCD should display the following sub-menu:

DOOR

>LOCK

UNLOCK

5. Press the Select button once to move the cursor to “LOCK” and then press the Enter button. The

display returns to the menu shown in step 3 above.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 58 59

Komentarze do niniejszej Instrukcji

Brak uwag

Quantum DAT 432/864 Loader Podręcznik Użytkownika Strona 35

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Napędy taśmowe Quantum DAT 432/864 Loader