Quantum LTO-5 Przewodnik Szybki Start Pobierz pdf (Strona 7)

Installing the Internal LTO-5 Tape Drive 7

LTO-5

Connecting the Internal Half-Height Drive Interfaces

As shown in figure 5, the rear panel of the internal LTO-5 Half-Height Tape Drive has

connectors for:

• 29-pin SFF-8482 SAS cable

Figure 5 Internal Drive

Interfaces

29-pin SFF-8482 SAS cable connector

4-pin Molex power connector

Connect the interface cables to the internal drive as follows:

1 V

erify that the system is shut down and the AC power cord is disconnected from the

facility AC power receptacle.

2 Conne

ct the SAS connector on the back of the tape drive to a serial SCSI host bus

adapter (HBA) installed in the server.

3 Ensure

that a 4-pin Molex power connector is plugged into the power inputs of the

SAS cable as shown in figure

4 Reinstall the system cover

5 Reconn

ect the system AC power cord to the facility AC power receptacle.

After connecting the internal drive interfaces, proceed to Restarting the Internal Half-

Height Tape Drive System in the following subsection.

Restarting the Internal Half-Height Tape Drive System

After connecting the internal drive interface cables:

1 Restart

the workstation or server system.

2 V

erify that the internal LTO-5 Half-Height Tape Drive comes on and completes the

Power On Self Test (POST) functions.

As required, proceed to Installing the LTO Driver Software on page 14.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Brak uwag

Quantum LTO-5 Przewodnik Szybki Start Strona 7