Quantum LTO-3 Drive Przewodnik Szybki Start Pobierz pdf (Strona 3)

2U Rackmount Quick Start Guide

Installing a Tape Drive in the

2U Rackmount

Follow these instructions to install a second tape drive or to

reinstall a tape drive after it has been removed for servicing.

1 Turn off the 2U Rackmount by pressing and holding the

power button on the front panel for three seconds.

2 Disconnect the power cable from the back of the

2U Rackmount.

3 Slide the 2U Rackmount out of the equipment rack.

4 Loosen the captive thumbscrews securing the top cover.

Slide the cover forward, then lift up to remove it. See

figure 5

Figure 5 Removing the Top Cover

5 Install two thumbscrews into the side of the tape drive

that will be located next to the outer wall of the

2U Rackmount. See figure 6

and figure 7 for

thumbscrew locations.

CAUTION: Before performing this procedure, you must

turn off the 2U Rackmount and disconnect it from its

power source.

NOTE: Extra thumbscrews are stored inside the

2U Rackmount (see figure 6

). Use the type

appropriate for your unit: SDLT 320 tape drives

use 6-32 (silver) thumbscrews; all other tape

drives use M3 (black) thumbscrews.

Figure 6 General Thumbscrew

locations

Figure 7 Specific Thumbscrew

Locations and Types











Extra

thumbscrews

SDLT 320 (6-32)

LTO-3 (M3)

SDLT 600 (M3)

DLT-S4 (M3)

1 2 3 4 5 6 7 8 ... 41 42

Komentarze do niniejszej Instrukcji

Brak uwag

Quantum LTO-3 Drive Przewodnik Szybki Start Strona 3

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Quantum LTO-3 Drive