Quantum Scalar i6000 Instrukcja Użytkownika Pobierz pdf (Strona 7)

Quantum Scalar i6000: Drive Replacement

6-67999-01 Rev A

October 2013

Remove and Replace the Drive 7

16 If the LEDs are displaying properly, you can vary on the drive. From the

Drives screen:

a Select the newly installed drive.

b Click the Vary On button.

c Click Cancel.

17 The library may update the drive sled firmware. Wait a few minutes to see if

a dialog box appears. If this happens, wait until it is complete before

continuing. The drive sled firmware update will take approximately 5

minutes.

18 Go to the rear of the module and observe the drive status LEDs and wait for

the following conditions to occur:

• Green LED 1 - solid green indicating port connectivity to either the

FC I/O blade or the customer FC switch

• Amber LED - off

• Blue LED - blinks one time per 10 seconds

• Green LED 2 - blinks at the same cadence as the other green LEDs on

the other drives in the module

Blue LED

Green Port LED 1

Amber LED

Green LED 2

19 Close the access doors.

20 Close the ticket that was generated for the failed drive.

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Quantum Scalar i6000 Instrukcja Użytkownika Strona 7