Quantum QVNR Instrukcja Użytkownika Pobierz pdf (Strona 32)

QNVR Installation Manual V1.2

QNVR installation and user manual

2.2 Constant record setup

2.2.1 Camera set up for Constant record mode

Use the SmartManager utility supplied with the VK2 cameras to set Stream 1 to the required

Resolution, Frame rate and Bit-rate. Note, the parameters set across all camera on the

system must not exceed the through put figures shown in Table 1 below:

IP Cameras

HD 720P

HD 1080P

QNVR

max.

Cameras

Total

Recording

frames

max.

Cameras

Total

Recording

frames

max.

Cameras

Total

Recording

frames

640 ips

320 ips

160 ips

Table 1

Note: It is possible to view a different lower resolution higher update, Live stream to that that

is being recorded, both on the local monitor and remotely over a network, in this case it is

recommended to set Stream 3 to this lower resolution.

2.2.2 QNVR set up for constant record mode

Once the camera’s stream parameters have been set, and the cameras have been

discovered by the QNVR, the QNVR must be set to record in the desired way. For Constant

recording, the following steps should be made:

1. Check that Normal (TL) stream setting is set to Stream 1.

2. If Live viewing is to be done in a lower resolution, check that IP Camera > Basic > Live

stream is set to Stream 3.

2.3 Event Boost record setup

2.3.1 Camera set up for Event Boost record mode

Use the SmartManager utility supplied with the VK2 cameras to set up the Event Boost

feature, this is found in the Event section of the cameras set up menu.

It is necessary to:

1. Define the type of event input that will trigger the camera: Event > Event in

2. Define the stream parameters (Stream 1) for Non-Event and Event situations: Event >

Event out

3. Link the Input to the Output in the Event Map: Event > Event Map

For more details refer to the camera installation manual.

2.3.2 QNVR set up for Event Boost record mode

Once the camera’s stream parameters have been set, and the cameras have been

discovered by the QNVR, the QNVR must be set to record in the desired way. For Event

Boost recording, the following steps should be made:

1. Check IP Camera > Basic > Normal = Stream 1

2. Check IP Camera > Basic > Motion = Stream 1

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 90 91

Komentarze do niniejszej Instrukcji

Brak uwag

Quantum QVNR Instrukcja Użytkownika Strona 32

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Quantum QVNR