Quantum FastStor 2 Podręcznik Użytkownika Strona 50

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 49
50 6-00515-03 Rev A
Cleaning cartridge is
incompatible
Make sure you are using an allowed cleaning cartridges
(see
Specifications).
Expired cleaning cartridge Verify the number of cleanings per cleaning tape for your
media type (see
Specifications).
Bad/defective/contaminated
media
If the Media Attention LED is cleared and the drive has
been cleaned, and then immediately reappears each time
a particular cartridge is reloaded, that cartridge should be
suspected as being defective, if it is not an invalid cleaning
cartridge.
If this occurs, export the cartridge and load a
known good cartridge. In some cases, a
cartridge can be worn out, have a defective
cartridge memory, or have been formatted as a
Firmware Upgrade Tape.
Any cartridge that is suspected of being
defective or contaminated should NOT be
reused in any drive.
Errors Displayed on Front Panel
“!” in autoloader operator panel
inventory display
See Operating the Autoloader for more information.
There is an error code on the
LCD display
Look up the error code, try to resolve the failure, and
power cycle (see
Viewing Autoloader Error Codes).
Device Not Detected on SCSI Bus
Connected to a high voltage
differential SCSI bus/host
system adapter
Attach device to a LVD SCSI host system adapter/bus.
SCSI cable length exceeded, use shorter cable, or
remove other devices from the bus. Device not properly
terminated (see
Installation Issues).
Power on device before powering on the host system.
Check that the device has been powered on and is not in
an error state.
SCSI Errors
Connected to a high voltage
differential SCSI bus/host
system adapter
Attach device to a LVD SCSI host system adapter/bus.
SCSI cable length exceeded, use shorter cable, or
remove other devices from the bus (see
Installation
Issues).
Device not properly terminated.
Problem Solution
Przeglądanie stron 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag