
Chapter 3 Installing Your Tape Drive
Configuring and Installing a Tabletop Tape Drive with SCSI Interface
SDLT 600 Product Manual 65
Configuring and Installing a Tabletop Tape Drive with SCSI
Interface
3
This section provides instructions for configuring and installing the
tabletop Fibre Channel model of the SDLT 600 tape drive.
Tabletop Fibre Channel
Tape Drive Model
3
Follow these steps to connect a tabletop Fibre Channel SDLT 600 tape
drive:
1 Prior to connecting the SDLT 600 tape drive to the host computer, be
certain the tape drive and computer are turned off.
2 Remove the Fibre Channel protective caps from the rear of the drive.
3 Remove the fiber optic cable protective caps and insert the fiber optic
cables into the Fibre Channel connector, as shown in
figure 17. The
connector is fully seated when it snaps into the port.
Note: You can connect a Fibre Channel connector while the tape
drive is still powered on; this capability is known as “hot-
swappable” or hot-pluggable.”
When connecting to the Fibre Channel port, make sure to
use a 50μM Fiber core fiber optic cable with an LC, Duplex
connector.
Komentarze do niniejszej Instrukcji