Quantum DLT-V4 Instrukcja Użytkownika Pobierz pdf (Strona 54)

Chapter 5 Installing the Tabletop SCSI Tape Drive

Connecting the SCSI Interface Cables

DLT-V4 Product Manual 38

Figure 19 SCSI ID Selector

Switch

Connecting the SCSI Interface Cables 5

In the final installation stage, you connect the SCSI and power cables to

the tape drive.

To connect the SCSI and power cables to the tape drive, follow these

steps:

1 Shut down the operating system and power down the server or

workstation.

2 Power off all peripheral devices, such as printers and other SCSI

devices.

3 Obtain a SCSI cable with an open 68-pin, high-density connector.

4 Connect one end of the SCSI cable to one of the connectors on the rear

panel of the tape drive as shown in figure 20

. Either SCSI connector

works equally well. Figure 20

does not show a terminator because

none of the three tape drives in the illustration are at the end of the

SCSI bus.

Caution: Do not go to step 3 until you have completed steps 1

and 2. Failure to follow these instructions may result

in damage to the tape drive or other devices.

Press here to decrease

SCSI ID

Press here to increase

SCSI ID

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 96 97

Brak uwag

Quantum DLT-V4 Instrukcja Użytkownika Strona 54