Quantum PX502 Podręcznik Użytkownika Pobierz pdf (Strona 12)

PX502 Tape Library Quick Start Guide

Table 5 Setting Up the Cabinet

Setting the Date and Time

To set the date and time:

1 From the Setup screen, use the up and down arrows to

highlight Date and Time and press Enter.

The Date and Time screen displays (see figure 21

Figure 21 Date and Time Screen

The Date and Time screen displays the following

information about the library:

Cabinet Options Description

Host bus Sets the SCSI ID for both the

library and tape drives.

Stack role Assigns the library stack role

as Master, Slave, or Stand

alone (solo). There can be only

one Master library in a

multiple stack. Once

configured as a slave, all

library OCP functions can be

controlled via the Master

library OCP. The library model

number will also change to

PX500S indicating a stacked

library configuration. The

library model number is

available from the home

screen on the Master library

OCP.

Left load port Enables or disables the left

load port

Right load port Enables or disables the right

load port

Drive FUP from tape Allows you to perform a tape

drive firmware update from a

firmware update tape

cartridge.

2 Use the up and down arrows to view or edit the date

and time information. Press Enter to accept the new

settings.

3 When you are finished viewing/editing the date and

time information, press Exit to return to the Setup

screen.

Setting Network Information

To view or edit the network information:

1 From the Setup screen, use the up and down arrows to

highlight Network and press Enter.

The Network screen displays (see figure 22):

Figure 22 Network Screen

The Network screen allows you to view or edit the

following network settings:

• DHCP (default setting)

• IP address

• Subnet mask

•Default gateway

2 Use the up and down arrows to select the network

setting you wish to view or edit and press Enter.

When you are finished viewing/editing the network

information, press Back to return to the Setup screen.

3 For the network information such as the IP address to

be active, you must reboot the library by holding down

the power button located on the front of the library

(see figure 16).

The library shuts down.

4 Push the power button to start the library.

The PX502 tape library is initially configured and ready

for use.

OTE: The library must be offline to change these

settings.

1 2 ... 7 8 9 10 11 12 13 14

Komentarze do niniejszej Instrukcji

Brak uwag

Quantum PX502 Podręcznik Użytkownika Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Quantum PX502