Quantum Scalar 100 Podręcznik Użytkownika Pobierz pdf (Strona 25)

SNC 6101 User’s Guide 21

Configuring the SNC 6101

You can configure the SNC 6101 as soon as you have installed it in the Scalar 100 and all appropriate

cables are in place. Configuration defines these values for the SNC 6101:

• IP address and subnet mask

• gateway address

• host name

To cable the service port to your laptop/desktop computer

1 Find the null modem cable supplied with your SNC 6101 (Refer to Unpacking and Inspecting

on page

14).

2 Connect one end of the cable to the DB9 connector on the SNC 6101 that is labeled “null modem.” See

Figure 1

on page 8 for the location.

3 Connect the opposite end of this cable to an available COM port on your laptop/desktop.

To configure HyperTerminal for operation as a service terminal

1 Connect a laptop/desktop computer to the SNC 6101 null modem port with the null modem serial cable

provided. See Figure 10

Figure 10 Service Port Connection to a Terminal Device

Note

Configuration requires that you access the SNC 6101 command line interface

by connecting the service port (null modem) on the SNC 6101 to an RS-232

DTE terminal or desktop/laptop computer that is running terminal emulation

software. Most operating systems offer either Windows HyperTerminal or

another default terminal emulation program. The following installation

procedures use HyperTerminal as a sample program.

Note

Procedures for configuring your laptop/desktop as a service terminal are

provided in Configuring the SNC 6101

on page 21.

Note

Configuration commands using the service port are available in the SNC

Firmware 4 User’s Guide.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Brak uwag

Quantum Scalar 100 Podręcznik Użytkownika Strona 25