Quantum Scalar 100 Podręcznik Użytkownika Pobierz pdf (Strona 48)

44 Maintenance

At the service terminal, enter the

fcShow command to view the

status of each FC interface that

is installed and connected.

In the output of the fcShow command, look for the

Firmware State column.

From the service terminal, enter

the fcShowDevs command to

show the SCSI target devices

that are connected as seen by

the Fibre Channel interface.

Check to see that all SCSI target devices are seen

by each FC interface.

Verify that all (or the designated)

target devices are available to

the Host systems.

If the designated devices are NOT available,

reboot the Host and check again.

Use the fcShowNames

command and save the

configuration values at a location

easily accessed if the SNC 6101

fails.

For more information on saving the configuration,

refer to the ADIC Management Console User

Guide.

Disconnect the RS-232 cable

from the and from the service

terminal.

None.

End of repair.

Table 5 Post Replacement Checklist

Step Actions Comments and References

1 2 ... 43 44 45 46 47 48 49 50 51 52

Brak uwag

Quantum Scalar 100 Podręcznik Użytkownika Strona 48