Quantum Scalar 100 Podręcznik Użytkownika Pobierz pdf (Strona 35)

SNC 6101 User’s Guide 31

Once installed, the service runs automatically and does not require further system administrator interaction.

From the ADIC Management Console, you can see the Fibre Channel that the host is connected to and you

can tell whether the host is online or offline. For software updates, visit “Service and Support” at

www.adic.com

Adding and Removing Hosts

After SFM is enabled, you may want to add a Host (or Initiator) to the SAN configuration or remove it from

the SAN configuration. This section describes how to add and remove hosts.

Adding a Host to the SAN Configuration

You can connect a new host to the SAN at any time. SFM automatically adds the new host to the database

as soon as the host is attached to the SAN. If you want to attach a new host at this time, refer to Attaching

a New Host to the SAN below. Otherwise, if you want to configure SFM before attaching the host, refer to

Adding a Host Before Attaching it to the SAN

on page 31.

Attaching a New Host to the SAN

When you attach a new host to the SAN, SFM automatically detects the host and adds it to the SFM

database. When you connect or refresh the SNC 6101 from the ADIC Management Console, you can see

the new host in the SFM Access Settings window. If the Host Registration Service is running on the host,

SFM automatically obtains the host parameters. If the Host Registration Service is not running on the host,

SFM only knows the WWN of the HBA. In this case, you must manually enter the other host parameters.

Follow these steps to add a new host to the SAN configuration:

1 Connect the host to the SAN.

2 If you need to install the Host Registration Service, refer the ADIC Management Console User’s Guide.

3 If you need to determine LUN assignments for the devices you want to assign to the new host, refer to

the ADIC Management Console User’s Guide.

4 For further information about entering host parameters, refer to the ADIC Management Console User’s

Guide.

5 Refer to the ADIC Management Console User’s Guide to assign access permissions for the new host.

6 For information on enabling and configuring the Scalar Firewall Manager, refer to the ADIC

Management Console User’s Guide.

Adding a Host Before Attaching it to the SAN

You can add a host that has not yet been attached to the SAN and configure its access permissions

beforehand. For more information, refer to the “Add VPS/SFM Hosts” section of the ADIC Management

Console User’s Guide.

After the new host has been added you can assign its access permissions.

Removing a Host from the SAN Configuration

You may want to remove a host from the SFM database. SFM will prevent you from removing a host that is

online. For more information, refer to the “Deleting VPS/SFM Hosts” section of the

ADIC Management

Console User’s Guide.

Note

You must refresh the SNC 6101 from the ADIC Management Console to see

host status changes.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Quantum Scalar 100 Podręcznik Użytkownika Strona 35

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Quantum Scalar 100